Wiring Harness for Dual Vision X Lights - Toggle Switch - 10' Long

Video Transcript for Vision X Vehicle Lights P-HARNESS2XIL Review

Today we're going to review part number P-HARNESS2XIL. This is the Vision X Wiring Harness for Dual Vision X Lights. This universal wiring harness will let you run power to two Vision X lights. It does include a toggle switch right here, to turn it on or off and there is 10 feet of wire on this toggle switch, which will allow you to mount the switch wherever you'd like it. This whole harness is a weather proof construction. It does have the 2 industry standard triple sealed Deutsch connectors. You can see one right here and one right here.

Those are what would plug into your lights. It does also have the 12 volt relay, has in-line 30 amp fuses, one here and one here on the toggle switch wire. All of the harness is a 14 gauge wire. So, basically when you go to install this, in other words, here's you on and off toggle switch. Again, there's 10 foot of wire, so you can mount it wherever you'd like.

The in-line fuse and then what you'd do with this, the red wire coming out of the other side the in-line fuse would go to the positive post of your 12 volt battery in your vehicle. Over here, you have a in-line fuse again with ring terminal on the end. This would go also to the positive post of your battery to supply power. This other individual wire with just the ring terminal on it, that would be a ground wire. You'd run this to a good, clean ground on the vehicle.

Then the other two coming off are the Deutsch connectors, which they both here would plug into the your lights and then the ring terminal wires also coming off the connectors, those would also be needed to be a good clean ground also. Very simple installation of the wiring harness. That should do it for the review on part number P-HARNESS2XIL, the Vision X Wiring Harness for Dual Vision X Lights. .